![]() So, I'm assuming the Chargery is cutting power to the LVD wire. I set the cell amp hour and watt hour for my 4 cells (280ah LFP). Everything seems to be totally correct, and right where I would expect it to be. 5843 adobe drive full Both bathrooms were just renovated with modern finishes, including Quartz Counters and a large walk-in shower in the primary bathroom. The screen is reading 86% SOC, 3.2ish volts (I don't remember the voltage exactly) cells are top balanced within 10mv. ![]() Now, only 1 of the wires is outputting 12v, and I think its the HVD wire (the Chargery diagram isn't the easiest to read). I had to connect, re-connect, re-calibrate my shunt, top balance, (not necessarily in that order) and since then, that has changed something about the HVD and LVD wires. When I first setup my cells, both HVD and LVD had power (like they should). (Y'all know this.) My problem is-only one of the wires is outputting 12v. The Chargery has 2 "outputs", a 12v pin/wire that are constantly outputting 12v, one for and High Voltage Disconnect, one for Low Voltage Disconnect. I don't think this has been covered before, and I can't figure out my issue by reading the manual. Just have to connect the wires when I get this issue figured out. no charger connected yet, but have all the wires run to a vehicle powered Kisae DMT1250.The phone number for Danny is (785) 423-6955 (Nextel Communications, Inc). ![]() Heather M Guy, Marlo L Johnson, and three other persons are also associated with this address. Currently powering some LED's while I work on our van conversion The residential address for Danny is 15843 Adobe Drv, Hudson, FL 34667-4008.
0 Comments
Leave a Reply. |